Freescale-semiconductor i.MX27 PDK 1.0 Bedienungsanleitung PDF herunterladen (Seite 22)

i.MX27 PDK 1.0 Hardware User's Guide, Rev. 1.0 Freescale Semiconductor

3-4

3.1.3 Connect Development Platform to PC; Run Preloaded Image

Figure 3-4 illustrates the switches and PC connection.

To connect the 3-Stack platform to your host PC, use these steps:

1. Connect one end of an RS-232 serial cable (included in the kit) to a serial port connector (CON4)

on the Debug board and connect the other end to a COM port on the host PC.

⎯ Configure SW4-1 to ON.

⎯ Make sure that SW4-8 is ON, to supply power to all three boards.

⎯ Configure SW4-2 to OFF.

2. Confirm that the Bootstrap switches (SW5–SW10) are set for NAND boot; see the following table.

Boot Mode

Device

SW5 SW6

(Boot4)

SW7

(Boot3

SW8 SW9 SW10

UART/USB

Bootloader

X 0 0 0 0 0

8-bit NAND

Flash (2KB

page) Ext

X 0 0 0 1 0

Figure 3-4 Connecting the Platform to Your PC

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 52 53

Keine Kommentare

Freescale-semiconductor i.MX27 PDK 1.0 Bedienungsanleitung Seite 22